Build 2024.3 RFCs

RFC 144

A command was created to add a .tif/.pdf file as a rendition to a .dwg for where it is identified that the .tif/.pdf is wet signed version of the .dwg. The command is available to Drawing Managers and higher and it is the user’s responsibility to locate the drawings they wish to perform the command on.

RFC 180 & 182

Workflows were updated for documents with document types FE Feasibility or MF Manufacturer. FE Feasibility documents only require a Tech Approver signature, and MF Manufacturer only require an Admin Approver signature when the revision number is < 1.

RFC 205

Sheet numbering in Civil3D has been aligned with the Revit and upcoming Inventor integrations, allowing multiple sheets in a model to be numbered at once with a new dialog. This replaces the old Apply Temporary/Apply Permanent toolbar buttons. 

RFC 214

When creating a project copy of a document, the workflow is automatically routed to the Draft State. Please note that there may be a small delay in the routing to Draft State, which may occasionally require a client refresh to update.